News

You are here:Home > News > News
Assessment of Attitudes and Expectations of Switchable Glass Among United States Window Manufacturers Part 3
Published: 2015-6-22 22:57:36

window manufacturers, likely serving specialty markets,
may be among the first companies to offer switchable glass
products to their customers.
Pearson correlation analyses also were conducted to
examine the association between manufacturers’ interest in
offering switchable glass products and the percentage of
their window products that are sold to residential markets.
The association between the percentage of a
manufacturer’s window products offered to residential
markets and a manufacturer’s interest in offering
switchable glass products to residential homeowners is
moderately negative (-0.237), and somewhat statistically
significant (p<0.10). The association between the
percentage of a manufacturer’s window products offered to
residential markets and a manufacturer’s interest in
offering switchable glass products to commercial
developers is slightly negative (-0.148) and not significant
(p<0.25). Thus, to some degree, the data indicate that as
window manufacturers’ product mix shifts away from the
residential market and toward the commercial market,
interest in offering switchable glass products increases.
MULTIPLE LINEAR REGRESSION ANALYSIS
The previously completed hypothesis tests found that a
window manufacturer’s interest in offering switchable
glass products over the next 3 years differs quite
significantly based on the amount of the firm’s annual
sales volume and somewhat significantly based on the mix
of a firm’s sales to residential and commercial customers.
The researcher wanted to use this information to develop
models that predict a window manufacturer’s likelihood of
offering switchable glass products over the next three
years to the residential market and to the commercial
market. The technique employed is multiple linear
regression. In this particular analysis, the dependent
variable is “likelihood of offering switchable glass
products over the next three years,” and the independent
(predictor) variables are “company sales volume” (Tier I
versus Tier II) and the status as a company equal to/more
likely or less likely than others to offer window products to
the residential market (Group A versus Group B).
The data in Table 10 indicate that approximately one-fifth
(17.8%) of the variation in manufacturers’ interest in
offering switchable glass products to residential
homeowners over the next three years is explained by
differences in their annual sales volume and by differences
in the percentage of window products sold to the
residential market. Further, the analysis results in a test
statistic value (F) of 5.867 and a high level of statistical
significance (p<0.01).

Table 10. Multiple Linear Regression Results
Dependent Variable: Interest in Offering Switchable
Glass Products to Residential Market/Next 3 Years
Adjusted r-square 0.178
F 5.867
Significance p=0.006
Extending the regression analysis to focus on
manufacturers’ interest in offering switchable glass
products to the commercial market over the next 3 years,
the model has less predictive power. Just 3.7% of the
variation in manufacturers’ interest is explained by the
independent variables. The statistical significance of this
result also is quite low (p<0.25).
Table 11. Multiple Linear Regression Results
Dependent Variable: Interest in Offering Switchable
Glass Products to Commercial Market/Next 3 Years
Adjusted r-square 0.037
F 1.562
Significance p=0.228
CONCLUSION
The 2000 study of United States window manufacturers
offers business decision makers a unique perspective on
the attitudes and expectations of these manufacturers
toward switchable glass products. The study found strong
levels of awareness of switchable glass technology in
general, but substantially lower levels for selected types of
switchable technologies. Since the completion of the
research (summer 2000), commercialization activity and
concomitant publicity and press coverage have grown
markedly, particularly in the area of suspended particle
device technology. This likely has increased awareness of
SPD technology specifically and that of switchable glass
technology in general. Knowledge of switchable glass
technology also is quite limited and is primarily restricted
to the fact that switchable glass can control the amount of
light transmitted through glass, and that this control
function is accomplished through the use of an electrical
interface.
The study finds window manufacturers’ expectation of
end-user interest in switchable glass over the next three
years is strong in both the residential and commercial
markets. Further, manufacturers’ interest in offering
switchable glass window products is fairly strong as well.



A variety of attributes of switchable glass products were
presented to respondents. Those surveyed cite durability,
reduction of glare and heat, the ability to be used with lowe
glass and control of daylight as the attributes they expect
will be most important to end-users. A notable difference
is observed regarding the importance of an almost
instantaneous tint change. Respondents believe that an
almost instantaneous tint change will be more important to
the residential market than it will be to the commercial
market.
Expectations for ma rket penetration of switchable glass
products vary by segment. Respondents serving the
residential segment expect penetration of switchable glass
in the residential market to be 3.6% by 2005 (installed or
retrofitted), while those offering products to the
commercial market anticipate a penetration rate in that
market by that time of 6.2%.
Some degree of price sensitivity is observed regarding
switchable glass products for windows, with nearly half of
all respondents claiming their company would be likely to
offer switchable glass products if the incremental
manufacturing cost per square foot were in the range of
$11 to $25. Nearly one-seventh (13.5%) said their
company would be likely to offer these products at
incremental manufacturing costs of $26 to $50 per square
foot.
Finally, statistical testing revealed that significant
differences exist in manufacturers’ interest in offering
switchable glass products to the residential or commercial
markets over the next three years based on the size of a
company’s annual revenue. Individuals from smaller
companies express a significantly higher level of interest
in offering switchable glass products than do their larger
counterparts. Individuals whose companies offer a lower
percentage of window products to residential customers
than other companies sampled also are more likely to
claim their companies will be interested in offering
switchable glass products over the next three years,
although this result is only moderately statistically
significant.
Integrating firm data regarding annual sales volume and
the amount of window products offered to each market
into a multiple linear regression analysis leads to several
conclusions. The analysis finds that these two variables
account for nearly one-fifth of the variation in
manufacturers’ interest in offering switchable glass
products to the residential market over the next three years.
This result is highly significant. Less predictive and less
significant is the model’s ability to forecast manufacturers’
interest in offering switchable glass products to the
commercial market over the next three years.

The information developed from this nationwide study of
window manufacturers signals opportunities for companies
involved in developing and marketing switchable glass
products. Awareness levels are strong, and anecdotal
evidence suggests this level may be rising due to a
growing amount of related publicity. However, in-depth
knowledge of specific switchable glass technologies and
their inherent benefits is limited. Interest levels in the
technology are fairly strong, as are the expectations for the
technology’s market penetration. However, these positive
forces are somewhat offset by a degree of perceived price
sensitivity regarding the technology that is exhibited by
many of the window manufacturers surveyed. The study’s
findings indicate that incremental manufacturing costs of
$100 or more per square foot will meet with substantial
resistance by window manufacturers. Even so, it is
possible that price sensitivities may decline as end-user
demand increases for switchable glass products. In the
final analysis, optimal commercialization of switchable
glass technology will occur when market demand
ultimately warrants the incremental costs associated with
the production and sale of switchable glass products, thus
leading to an acceptable and sustainable return on
investment for the companies involved.
REFERENCES
1. M.R. LaPointe and G.M. Sottile, “2000 Survey of
Window Manufacturers on the Subject of Switchable
Glass,” Proceedings of SPIE – The International
Society of Optical Engineering, Solar and Switching
Materials, Vol. 4458, p.112, 2001.

© 2002 Society of Vacuum Coaters 505/856-7188 
45th Annual Technical Conference Proceedings (2002) ISSN 0737-5921



Back
Previous:Assessment of Attitudes and Expectations of Switchable Glass...
Next:Assessment of Attitudes and Expectations of Switchable Glass...
Copyright @ Guangzhou Hui Material Technology Co., Ltd. E-mail:info@gzhhmt.com
Address: Guangzhou Science City Kefeng Road 31 - South China New Materials Innovation Park Phone: +86-20-62315688 Fax: +86-20-62315680